Mobotix – How do I make the connections?

Power Supply Using A Switch

  1. Connect the factory pre-installed cable of the camera to the Camera connector of the Network Power Adapter.
  2. Connect the LAN/Power connector of the NPA to an Ethernet connector of the switch/router or the Ethernet wall outlet.
  3. Plug the RJ45 connector of the external power unit into the PC/Power connector on the Network Power Adapter.


IP addresses in the diagram are shown only as an example

Power Supply When Connected Directly To A Computer

  1. Connect the factory pre-installed cable of the camera to the Camera connector of the Network Power Adapter.
  2. Connect the PC/Power connector of the Network Power Adapter to the Ethernet port of the computer.
  3. Plug the RJ45 connector of the external power unit into the LAN/Power connector on the Network Power Adapter.

 

 

IP addresses in the diagram are shown only as an example

Power Supply (PoE IEEE 802.3af) Using Power-over-Ethernet Products

Connect the factory pre-installed cable of the camera to the Ethernet connector of the PoE switch/router. The switch/router must support the PoE standard IEEE 802.3af.

 

IP addresses in the diagram are shown only as an example

 

Bookmark the permalink.

Comments are closed.